Battipav VIP Manual De Instrucciones página 21

Battipav srl
3) DEVICE FOR DISCONNECTION FROM THE
MAINS (PLUG):
Machine power supply point.
During the maintenance phases, take out the
device plug in order to disconnect the machine
from the mains.
CUTTING ON THE TABLE
CAUTION
BEFORE PERFORMING THE CUTTING OPERATIONS,
MAKE SURE THAT THE MATERIAL IS PROPERLY
LEANED AGAINST THE TILE STOPPER.
CAUTION
BEFORE STARTING
10
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEFT FREE
AROUND THE MACHINE (Pos. 2).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR
THE MACHINE
OPERATIONS.
THE OPERATOR STANDS IN THE WORKING
POSITION (Pos. 1) DURING THE DIFFERENT
MACHINE OPERATION PHASES.
Take the disk to the 0° position with the inclination
11
adjustment knobs.
Position the piece which needs cutting on the
working table and make sure that it is properly
leaned against the tile-stopper. If necessary, a
bearing square can be of help.
CAUTION
THE MILLIMETRE RULER PLACED ON THE
WORKING TABLE
CARRYING OUT OF LINEAR CUTTING.
12 In order to carry out any diagonal cutting lean
the tile against the square the way it is shown in
picture 12 and go on with the cutting operation.
THE CUTTING
DURING THE CUTTING
HELPS ONLY WITH
CUTTING A SURFACE AT 45°
CAUTION
Before positioning the motor head, make sure that:
• the machine is off;
• the cutting tool is not moving;
CAUTION
Take the cutting blade to the 45° position with
12
the inclination adjustment knobs.
Lock the motor carriage at the max. cutting
depth with the locking lever.
Picture 13 shows the proper way the machine
13
should be used.
With the VIP machine it is also possible to set out:
a) the cutting length with the cutting adjustment
11
knobs.
b) the cutting depth with the locking lever.
13
c) the straight cut measurement with the tile
11
bearing square as well as the ruler placed on
the working table.
d) the cutting adjustment with the specially
provided indicator and ruler placed on the slide
rail.
In order to carry out special working it is possible
14
to set out any cutting inclination ranging from 0°
to 45° as marked on the machine side.
CAUTION
BEFORE ANY CUTTING MAKE SURE THAT THE TILE
TO BE CUT IS PROPERLY LEANED AGAINST THE
TILE-STOPPER.
THE
GB
21