Battipav VIP Manual De Instrucciones página 20

GB
In case of machine disassembly, perform the
opposite operations.
CHECKING BEFORE USE
CAUTION
THE VIP MACHINE HAS BEEN DESIGNED FOR
WORKING EXCLUSIVELY WITH WATER.
Before any cutting operation, make sure that the
7
water level inside the tank is correct.
CAUTION
Before using the machine, check there is power
supply.
CAUTION
ADJUSTMENT OF COOLING WATER
Through an on-off valve placed on the disk protection,
the water fl ow can be adjusted according to the type
of material to be cut.
An innovative cooling system makes it possible and
allows the disk to be always wet.
CONNECTING TO POWER SUPPLY
CAUTION
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) with the
following characteristics:
RCCB
Transformer
N.B. To ensure correct functioning, periodically
check the effi ciency of RCCBs by pressing the
push-button on the front of the device.
• Make sure that the section of the power supply
cable cores has been measured according to the
starting current and its length.
For cables up to 50 m long, a section of 2.5 mm
is enough.
• Before connecting the machine to the power
socket, check that the power supply voltage
20
In 6 A Id 30 mA
230 V 50 Hz 1500 W
Transformer
2
corresponds to that shown on the plate on the
machine.
• The machine must be connected to an effective
earth wire.
In case of doubt, do not connect the machine.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment,
disconnect the machine from the supply mains.
Loosen both nuts located on the blade cover guard
and remove it.
Remove the blade fi xing nut using the 19 mm
spanner and the 5 mm Allen wrench.
CAUTION
THE BLADE FIXING NUT HAS A LEFT-HAND
8
THREAD.
After dismantling the blade, clean the blade fl anges
carefully and check them for wear.
Grease any surface with fi ne oil and install the new
blade. Check for correct direction of rotation as
clearly indicated on the tool.
CONTROL DEVICES
CAUTION
The VIP machine is equipped with a control
9
board made up of:
1) START BUTTON (GREEN COLOUR):
Press the button fully to activate machine
starting.
2) REGULAR STOP BUTTON:
Press the button fully to activate machine
stop.
Battipav srl