Switching On And Setting The Time; Water Hardness; Showroom Mode - Teka HLC 847 SC Guía De Uso

When plugging the oven in for the first time,
the logo will appear followed by 12:00
flashing on the screen.
You must set the time in order to use the
oven.
To do this select the hour with the left control
and the minutes with the right one.
Confirm the settings by pressing the
button or waiting a few seconds.
Confirm the time appearance (standard/retro/
hide the clock) by pressing the
waiting a few seconds.
An audible signal will be heard confirming that
the time has been set on the screen.
To change the time:
With the oven in standby (start screen), hold
the button until the time begins to flash.
Follow the previous steps to change the time.
The sensitivity of the touch keys adapts
continually to environmental conditions.
Make sure the surface of the control panel
is clean and free of obstacles when
plugging in the oven.
If the display does not respond correctly
when you touch the keys, unplug the oven
for a few seconds and then plug it in
again. Doing this causes the sensors to
adjust automatically so that they will react
once more to fingertip control.

WATER HARDNESS


After setting the clock, you need to set the
water hardness.

The Water Hardness option appears on
the display.

To change the option rotate the right
control.

Press to confirm the option.

If you wish to modify the water hardness,
after the first settings, rotate the left
control to the position corresponding to
the Steam function

Rotate the right control until the Water
hardness symbol
side of the display.

Press

Rotate the right control to select the
desired water hardness.

Press
button or
Type
SOFT
MED
HARD
In the event of power failure, the water
hardness settings will be erased. Reset it
and program again after power restore.

SHOWROOM MODE

With the DEMO mode activated, you can
control the oven without heating. Activating
this mode is recommended if the oven is to
be plugged in at a showroom.
Activating DEMO mode
Press the buttons
on the programing mode, until
Then, set the time on the oven.
on the panel and the oven will work as normal,
but without heating up.
To deactivate DEMO mode, repeat the
same process.
appears on the right
to confirm the option,
to confirm.
Water hardness
Ca + Mg English French deg.
(ppm) deg. [°eH]
0 to 150 0 to 11
151 to 350 12 to 25 16 to 35
351 to 500 26 to 35 36 to 50
and
on the screen.
EN
.
German
[°dF] deg. [°dH]
0 to 15 0 to 8
9 to 20
21 to 28
simultaneously
Mode
5