PSC SP Ace Serie Guia Del Usuario página 19

All manuals and user guides at all-guides.com
Refer to the figures on the facing page when following these steps.
Locate the mounting position of the scanner and
1
install the mounting plate.
Route the cables through pedestal and connect them
2
to the scanner. Tighten the screw that secures the
interface cable to the scanner. Do NOT connect
cables to power or the terminal at this time.
Remove the appropriate cable routing knockout.
3
The three cable routing directions shown in step five
on the opposite page will help you determine which
knockout to remove. Remove all rough edges
around the knockout hole.
Attach the pedestal to the scanner using a flat-blade
4
screwdriver to tighten the captive screws.
Route the cables through the base. Three routing
5
options are shown.
Lower the scanner onto mounting plate and press
6
down to secure the scanner to the plate. Proceed to
the instructions titled Connecting the Scanner and
Power-Up Procedure to complete the installation.
R44-1132
P I
EDESTAL NSTALLATION
I
NSTRUCTIONS
15