PSC SP Ace Serie Guia Del Usuario página 17

All manuals and user guides at all-guides.com
Refer to the figure on the facing page when following these steps.
Locate the mounting position of the scanner and
1
install the mounting plate.
Remove the appropriate cable routing knockout.
2
The three cable exit directions shown in step five on
the opposite page will help you determine which
knockout to remove.
Remove all rough edges around the knockout hole.
3
Attach the power and interface cables to the scanner.
4
Be sure to tighten the screw that secures the inter-
face cable to the scanner. Do NOT connect the
cables to power or the terminal at this time.
Route the cables through the base. Three routing
5
options are shown.
Lower the scanner onto the mounting plate and
6
press down to secure the scanner to the plate.
Proceed to the instructions titled Connecting the
Scanner and Power-Up Procedure to complete the
installation.
R44-1132
C I
OUNTERTOP NSTALLATION
I
NSTRUCTIONS
13