Assembly; Tools Required For Assembly - Husqvarna TC 242T Manual De Operario

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 1/2" wrench
(2) 7/16" wrenches
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
CONNECT BATTERY (See Figs. 1 & 2)
WARNING: Not following installation instruc-
tions can result in sparks, arcing or open
flames which could lead to serious personal
injury or property damage.
WARNING: Ensure tractor ignition switch is in the
OFF position and ignition key is REMOVED.
TERMINAL END
BLACK
CABLE (-)
PROTECTIVE
SLEEVE

ASSEMBLY

Tire pressure gauge
Utility knife
GROUND
SCREW
(SILVER)
Fig. 1
• Locate silver ground screw on right side plate of tractor,
above right rear tire.
• Locate BLACK and RED battery cables in same area.
Ensure RED cable is securely attached to the starter
solenoid and the BLACK cable is not attached with
protective sleeve completely covering terminal end.
Pliers
• Using a ½ inch (13mm) wrench or socket, completely
remove the silver ground screw and set aside.
DO NOT discard, it will be reused later.
RED
CABLE (+)
PROTECTIVE
SLEEVE
GROUND
SCREW
(SILVER)
• On BLACK cable, slide protective sleeve back to expose
terminal end.
• Reinstall previously removed silver ground screw
through exposed terminal end and into location from
where silver ground screw was removed.
• Tighten securely. Visually inspect cable to ensure no
part of protective sleeve is trapped under the head
of the ground screw. If needed, loosen silver ground
screw, reposition sleeve and re-tighten screw.
ADJUST SEAT (See Fig. 3)
• Sit in seat.
• Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
• Release lever to lock seat in position.
6
BLACK
CABLE (-)
TERMINAL END
Fig. 2
A
Fig. 3