Disposal - GMC DB305SMS Manual De Instrucciones

8. Use the 6mm hex key provided to
loosen and remove the blade bolt.
(Loosen in a clockwise direction
as the blade screw has a left hand
thread) (Fig. r)
9. Remove the flat washer and outer
blade washer and the blade
10. Wipe a drop of oil onto the inner
blade washer and the outer blade
washer where they contact the
GB
blade
s
11. Fit the new blade onto the
spindle, taking care that the inner
blade washer sits behind the
blade (Fig. s).
IMPORTANT: Ensure the direction
of the arrow printed on the side of
the blade matches the direction of
the arrow on the side of the upper
blade guard
12. Replace the outer blade washer
(Fig. t)
13. Depress the Spindle Lock Button
(26) and replace the flat washer
and blade bolt
14. Use the 6mm hex key to tighten
the blade bolt securely (tighten in
an anti-clockwise direction)
15. Lower the blade guard, hold the
Rotating Blade Guard (12) and
Blade Bolt Cover (14) in position
and tighten the fixing screw
(Fig. u)
16. Replace the guard retraction arm
and secure onto the rotating blade guard (Fig. v) 17. Check that the blade guard operates correctly and covers the blade as
the saw arm is lowered
r
t
u
V
18. Connect the saw to the power supply and run the blade to make
certain that it is operating correctly
Adjusting the laser lines
• The lower laser is factory set to emit a laser line along the right-hand
side of the blade
• The upper laser is factory set to emit a laser line to the left-hand side
of the blade. This upper laser can be adjusted by the operator to suit
blades of different kerf widths
To adjust the position of the upper laser:
1. Check the blade is square with the table and zeroed on the bevel scale
(see 'Setting the table square with the blade' above)
2. Remove the laser cover by pulling it towards you
3. Switch on the laser lights with the On/Off Switch (2) (Fig. w)
4. Using a Phillips head screwdriver (not supplied), adjust the position of the
line from the upper laser by turning the Laser Pitch Control (4) (Fig. x)
w
5. Adjust until the left-hand laser line is aligned with the left-hand side of
the blade
6. Switch off the laser lights and refit the laser cover

Disposal

Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the
proper way to dispose of power tools
18
x