OHAUS i-DT61XWE Manual De Instrucciones página 6

EN-4
6. Disassemble the cable gland by loosening the cap nut and removing the
rubber seal. Pass the relay output cable through the cap nut, then spread the
rubber seal and place it over the cable.
7. Follow the previous step. Pass the cable through the body of the cable gland.
8. Connect the cable to the connectors on the relay board. Please check the
following CONNECTION section for details.
9. Pull in the bottom of the indicator. Re-install the 4 screws (Torque is
1.8N*m±0.5). Fasten the cap nut of the M16 gland.