Tools And Materials; Before You Begin - Kohler K-705700 Guia De Instalacion

Tools and Materials

Masking
Silicone
Tape
Sealant
Center
Punch
File
Assorted
Screwdrivers
Knife

Before You Begin

CAUTION: Risk of personal injury. Always wear safety glasses while cutting or drilling.
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass edge directly on the floor.
CAUTION: Risk of injury or product damage. Do not attempt to cut tempered glass. Tempered
glass shatters when it is cut.
CAUTION: Risk of product damage and property damage. This shower door is very heavy. Do not
install it to plastic shower modules or drywall unless additional support is provided behind the
wall.
NOTICE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
IMPORTANT! Record the model numbers from each box and the master model number on the
Homeowners Guide if you intend to save it, or in your records for later use. The numbers can be found on
the label, starting with a "K-". The proper model number will enable our customer service representatives
to quickly help you if needed.
Your new Kohler door can be installed with the door opening to either the right or left. Install the
door with the pivot side away from the showerhead for best results. These instructions show the
door installed with a left side swing. Doors that swing to the right would be opposite.
Handles are purchased separately. Install the handles following the installation instructions provided
with them.
These instructions cover both 30" (76.2 cm) to 48" (121.9 cm) and 60" (152.4 cm) models. Some steps
may pertain to only one model. Make sure to follow the steps for your model of door only.
Before starting the installation, lay out and identify all of the parts. Inspect them for damage.
Some steps in these instructions are specific to a right or left side hinge installation. Follow the
instructions which pertain to your installation configuration.
Closely follow the instructions pertaining to the sealant application on the door. Sealing areas other
than those shown may cause leaking.
Two people should perform this installation.
1064866-2-B
Level [4' (1.2 m)
Tape
to 6' (1.8 m)]
Measure
Claw
Drill and
Hammer
Assorted
Bits
Miter Saw or Hack Saw with
32 Teeth Per Inch Blade
Pencil or Felt
Tip Marker
Safety Glasses
Miter Box
2
Plus:
• Drop Cloth
• Tile or Masonry Bit
(if installing onto tile walls)
1/4" and 5/32"
Hex Wrenches
Pliers
Caulk Gun
Kohler Co.