Store The Machine; Troubleshooting; Technical Data - GreenWorks 2534202CT Manual Del Operador

EN
8.3

STORE THE MACHINE

• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
9

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca- Charge the battery
pacity is low. pack.
The bail switch is Replace the bail
defective. switch.
The safety key is Put in the safety
not put in. key.
The lawn is rough. Examine the mow-
ing area.
The blade height is Adjust the blade/
not set correctly. cutting height to a
higher position.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade/
tall, or the blade cutting height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
10

TECHNICAL DATA

Voltage
No load speed
Deck size
Height adjustments
Functions
Weight (without battery
pack)
Battery model
Charger model
12
Possible cause Solution
The blade is un- Replace the blade.
balanced and
worn.
The motor shaft is 1. Stop the mo-
bent. tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
The blade height is Increase the blade/
too low. cutting height.
The battery pack is Charge the battery
out of power. pack.
The grass clip- Remove the bat-
pings attach to the tery pack and
deck or the blade. check the deck.
Operation temper- Cool the machine.
ature of the ma-
chine is too high.
40 V
2800 RPM
19"
1 3/8 - 3 3/4" (3,5 - 9,5 cm)
3-in-1 Mulch & Rear Bag &
Side Discharge
54.2 lbs (24.6 kg)
29662/29472/BAF724 and
other BAF series
29692/29482 and other CAF
series