Maintenance And Care; Troubleshooting - DieHard DH153 Manual Del Propietário

• Cranking – When cranking
is detected, the charger will
automatically deliver up to its
maximum output as required by the
starting system for up to 3 seconds
or until the engine cranking stops.

12. MAINTENANCE AND CARE

A minimal amount of care can
keep your battery charger working
properly for years.
• Clean the clamps each time you
are finished charging. Wipe off
any battery fluid that may have
come in contact with the clamps to
prevent corrosion.
• Occasionally cleaning the case
of the charger with a soft cloth
will keep the finish shiny and help
prevent corrosion.

13. TROUBLESHOOTING

PROBLEM
The charger will not
turn on when properly
connected.
The battery is properly
connected, but the %
LEDs never lit.
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical
connection.
Battery is defective.
The battery voltage is
low.
• 10 •
• Cool Down – After cranking, the
charger enters a mandatory 3
minute (180 second) cool down
state. This is indicated by the
blinking Engine Start LED. After
three minutes, the % LEDs will
light in sequence and the Engine
Start LED will be lit.
• Coil the input and output cords
neatly when storing the charger.
This will help prevent accidental
damage to the cords and charger.
• Store the charger unplugged from
the AC power outlet in an upright
position.
• Store inside, in a cool, dry place.
Do not store the clamps clipped
together, clipped to the handle, on
or around metal, or clipped to the
cables.
Check for open fuse or
circuit breaker supplying
AC outlet.
Check power cord and
extension cord for loose
fitting plug.
Have battery checked.
Press the START/STOP
button to start charging.
SOLUTION