Resolving Errors - ABL Wallbox eMH1 Instrucciones De Uso

22
| Wallbox eMH1 – Resolving errors
5
Check the LEDs on the wallbox:
y While the charging procedure is active, the
blue LED will be continuously ON and the
green LED will be OFF.
y When the charging procedure has been
completed or interrupted, the blue LED will
flash every 2 seconds while the green LED
will be OFF.
NOTE
Completion of charging procedure
The vehicle determines when the charging procedure ends.
ƒ The charging procedure may be paused by the vehicle.
ƒ The charging procedure is automatically terminated by the vehicle upon completion.
6
Unplug the charging connector from the elec-
tric vehicle's charging inlet and close it.
7
Store the charging cable ready for the next
charging procedure.
y Wallbox with charging cable
Replace the charging connector in its
storage compartment.
y Wallbox with charging socket
Unplug the charging connector from the
charging socket and store the charging
cable: the charging socket flap closes
automatically.

Resolving errors

Errors may occur during the operation of the wallbox.
Description
The electric vehicle is not recognised.
Cause and suggested solution
ƒ The charging cable is not properly plugged in.
y remove the charging connector from the vehicle's charging inlet and plug it back in.
y For wallboxes with charging socket: also remove the charging connector from the charging
socket of the wallbox and plug it back in.
y Check the charging cable for damage and replace it if required.
1 sec 1 sec 1 sec 1 sec 1 sec 1 sec