Final Installation Check; Gas Models; Electric Models - KENMORE ELITE 796.6927 Serie Manual De Uso

FINAL INSTALLATION CHECK

Once you have completed the installation of the dryer
A
and it is in its final location, confirm proper operation with
the following steps and tests.
Is gas turned ON? (Gas Models only)
Is dryer plugged in? Dryer should always be plugged
into the proper outlet.
Gas dryer should use a
120-VAC, 60-Hz. grounded
3-prong outlet.
Electric dryer should use
a 4-wire connection which is
required for all mobile and
manufactured home
installations, as well as
all new construction after
January 1, 1996.
-- OR --
A 3-wire connection.
NOTE: A 3-wire connection
is NOT permitted on new
construction after
January 1, 1996.
Is dryer vent ductwork connected?
Is dryer level?
Perform the following tests before using the dryer.
INSTALLATION INSTRUCTIONS
Testing Dryer Heating

GAS MODELS

NOTE: If all air is not purged from the gas line, the gas
igniter may turn off before the main burner ignites. If this
happens, the igniter will reattempt gas ignition until all
the air is purged from the gas line.

ELECTRIC MODELS

Checking Venting
Vent ductwork should be checked for lint buildup
and cleaned at least once per year. If any noticeable
reduction in drying performance occurs, check ductwork
for obstructions and blockages.
Checking Levelness
Once the dryer is in its final location, recheck the dryer
to be sure it is level. Make sure it is level front to back
and side to side, and that all 4 leveling feet rest firmly
on the floor.
18 18
Close the dryer door.
Press the Power button to turn the dryer on.
Turn Cycle Selector Knob to Normal drying cycle.
Press the Cycle Selector Knob to start the dryer.
When the dryer starts, the igniter should ignite the
main burner.
After 2 minutes, open the door and check for heat. If
no heat is felt, verify the gas valve is on and check
other gas appliances for proper operation.
Close the dryer door.
Press the Power button to turn the dryer on.
Turn Cycle Selector Knob to Normal drying cycle.
Press the Cycle Selector Knob to start the dryer. The
exhaust air should be warm after the dryer has been
operating for 3 minutes.
After 2 minutes open the door and check for heat. If
no heat is felt, verify that BOTH breakers or fuses are
not tripped. Check for proper power cord wiring and
power supply.