Installation Instructions; Optional Pedestal; Electrical Requirements - KENMORE ELITE HE4 110.8586 Serie Manual Del Usuario

INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.
• Flat-blade screwdriver • Vent clamps
• Adjustable wrench that • Caulking gun and
opens to 1" (2.54 cm) or compound (for installing
hex-head socket wrench new exhaust vent)
(for adjusting dryer feet) • Tin snips (new vent
• Level installations)
• Wire stripper (direct wire • 1A" nut driver or socket
installations) wrench
• #2 Phillips screwdriver
Parts supplied
Remove parts package from dryer drum. Check that all parts are
included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
• For close-clearance installations between 31.5" (80.01 cm)
and 37" (93.98 cm), see "Plan Vent System" section for
venting requirements.
I_- 37" --_1
(93.98 cm)
Mobile home installations require metal exhaust system hardware
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-80O-4-MY-HOME ® (1-800-469-4663).
Are you placing the dryer on a pedestal? You can purchase a
pedestal separately for this dryer. This pedestal will add about
14" (35.56 cm) to the height of your unit for a total height of
approximately 52" (132.08 cm).
Optional pedestal
The pedestal is available in three colors
White - Part Number 42842
Biscuit - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call 1-80O-4-MY-HOME ® (1-800-469-4663).
Explosion Hazard
Keep flammable materials and vapors, such as
gasomine, away from dryer.
Pmace dryer at Beast 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can resumt in death, expmosion, or fire.
You will need
• A location that allows for proper exhaust installation. See
"Venting Requirements."
• A separate 30 amp circuit.
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."