Reinstalling/Using Beverage Center Again; Troubleshooting; Operation - Haier HEBF100 Serie Manual De Instalación Y Del Usuario

REINSTALLING/USING BEVERAGE CENTER AGAIN

If the beverage center has been placed in a horizontal or tilted position for any
period of time wait 2 hours before plugging it in to allow the refrigerant to settle.
1. Clean the beverage center. See "Cleaning."
2. Place the beverage center in desired location and level. See "Installation
Instructions."
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, re or electrical shock.
3. Plug into grounded 3 prong outlet.

TROUBLESHOOTING

OPERATION

Problem
Beverage center
does not operate
Beverage
center runs too
frequently
18
WARNING
Electrical Shock Hazard
Possible Cause(s)
The beverage center is
unplugged.
The fuse is blown or a circuit
breaker is tripped.
The beverage center
temperature control is set
to OFF.
Room is warm and/or humid This may be normal to maintain
Door opened often or left
open.
Gasket is not sealing
properly.
Solution
Plug beverage center into a
grounded 3 prong outlet.
Replace the fuse or reset the
circuit breaker.
Turn on the beverage center.
constant temperature during
hot and humid days.
Limit door openings. Make sure
the door closes completely.
Check gasket for proper seal.
Clean gasket if needed.