Clean Before Using; Reverse The Door Swing (Optional); Tools Needed - Haier HEBF100 Serie Manual De Instalación Y Del Usuario

NOTE: The waiting time allows the refrigerant to settle which avoids possible
damage to the compressor and the sealed system.
1. Use two or more people to move and install beverage center.
2. Remove all packaging material. This includes the foam base and all adhesive tape
holding the beverage center accessories inside and outside.
3. Inspect and remove any remains of packing, tape or printed materials before
turning on the beverage center.
4. Dispose of/recycle all packaging materials.

CLEAN BEFORE USING

After you remove all of the packaging materials, clean the inside of the refrigerator
before using it. See the cleaning instructions in "Beverage Center Care."
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold.
Shelves and covers may break if exposed to sudden temperature changes or
impact, such as bumping. Tempered glass is designed to shatter into many
small, pebble-size pieces. This is normal. Glass shelves and covers are heavy.
Use both hands when removing them to avoid dropping.

REVERSE THE DOOR SWING (OPTIONAL)

The door hinges are factory installed on the right-hand side. If you want the doors to
open from the opposite direction, you can reverse the door swing.

TOOLS NEEDED

•
5/16" Hex-head Wrench
•
3 mm Hex Key
IMPORTANT:
•
Before you begin, unplug the refrigerator, or disconnect power.
•
The door is heavy and fragile and the door front is glass. To avoid door glass
breakage, use both hands and grasp only the sides of the door to remove.
1. Using two or more people, gently lay the beverage center on its back.
2. Using a 5/16" hex-head wrench, remove the three hexagonal screws fastening the
bottom hinge to the cabinet, and set aside.
•
Putty Knife
a
Bottom Hinge Screws
a
9