Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operation
Before Starting
WARNING!
instructions and warnings on the machine and in
this manual before operating.
1.
The spark plug wire was disconnected for safety. Attach the
spark plug wire to the spark plug before starting.
Starting the Engine
1.
To avoid carbon monoxide poisoning, make sure the
engine is outdoors in a well-ventilated area.
2.
Insert the ignition key into the slot. See Fig. 5-1.
NOTE: Do not attempt to turn the key. Doing so may cause
it to break.
3.
Move the choke lever to the FULL choke position (cold
engine start).
4.
If the engine is warm, place the choke in the OFF position
instead of FULL.
5.
Push the primer five to seven (5-7) times, making sure to
cover the vent hole when pushing.
6.
If the engine is warm, push the primer button only once.
NOTE: Always cover the vent hole in the primer button
when pushing. Additional priming may be necessary for
the first start if the temperature is below 15° F.
7.
Grasp the starter handle and pull the rope out slowly, until
it pulls slightly harder. Let the rope rewind slowly.
8.
Pull the starter handle rapidly. Do not allow the handle to
snap back. Allow it to rewind slowly while keeping a firm
hold on the handle.
12
Read, understand and follow all the
Figure 5-1
9.
As the engine warms up and begins to operate evenly, slide
the choke lever slowly to the 1⁄2 choke position. When the
engine begins to run smoothly, move the choke to the OFF
position. If the engine falters, return to FULL choke, then
slowly move to 1⁄2 choke then the OFF position.
Stopping the Engine
1.
Run the engine for a few minutes before stopping to help
dry off any moisture on the engine.
2.
To stop the engine remove the ignition key and store it in a
safe place.
3.
Wipe all the snow and moisture from the area around the
engine.
WARNING!
Muffler, engine and surrounding areas
become hot and can cause a burn. Be careful and do
not touch when they are hot.
Engaging the Augers
Engage the auger by squeezing the auger control against the
upper handle. Release the control to stop the augers.
Engaging the Drive
Lift up slightly on the handle to allow the rubber paddles on the
auger to contact the pavement and propel the snow thrower
forward. Pushing downward on the handle will raise the augers
off the ground and stop the forward motion.
NOTE: Excessive upward pressure on the handle will result
in premature wear on the rubber auger blades which are
not be covered by the warranty.
5
Capítulos
Tabla de contenido
Solución de problemas
