Comelit 41SPG000 Manual Tecnico página 10

Address Programming Procedure
1. Connect the programmer to the device:
 Mount the detector to the programmer's base;
 Use insulated clip connectors for 41IOM010 addressable base module;

Use a cable with 5-pin block connector terminal for Comelit devices: 41PAM000, 41IOM022,
41IOM004, 41IOM040, 41ISC000, 41IOM000, 41IOM010, 41PAE020, 41SAB000,
41SCB000.
2. Power on the 41SPG000 Programmer unit.
3. Choose a programming menu, set the address and run the writing function.
4. Wait the end of the procedure and remove the device. It is not necessary to power off the
programmer unit.
5. Connect the next addressable device.
6. Proceed with the addressing or setting procedure.
NOTE: If you connect by mistake or other reasons more than one device to the 41SPG000 Programmer,
the unit will alert with an error message when you start writing and reading address function.
Messages
Successfully The new address or parameter is successfully set/ read.
Unsuccessfully The new address or parameter is not set/ read.
The set address is out the range 1 ÷ 250.
Wrong Address
No Device There is no addressable device connected to the programmer.
More Devices There is more than one device connected to the programmer.
Commun. Error Unsuccessful communication with the addressable device.
Overload The communication line is overloaded.
Short Circuit Short circuit in the communication line.
NONE This message is shown in those cases when the installer tries to set parameters to a
detector without reading first the current factory settings.
Operating with the Programmer Unit
1. Setting (writing) an address

Press the
you have entered other menus earlier.

Use the
Set address
Check address
Read parameters
Save parameters

Press the
New Address
Enter Address

Use the
row of the screen:
 Press the
position of the address, the cursor will move automatically to the first digit of the address.
 Press the
when the cursor is blinking over it. When the cursor is over the least significant digit (the
last right digit) the increasing is done with transfer to the next two most significant digits.
(Esc) button several times to exit back to the main programming menu in case
(Down) buttons to choose the "Set Address" menu.
(Up) and
(Enter) button to enter the menu.
001
(Edit) and (Right) buttons to set address for the device displayed on the first
(Right) button to move the cursor on the right. When is reached the last
(Edit) button to increase the digit with one unit. You can increase the digit
41SPG000 – Instruction Manual
10