Idiomas disponibles
Idiomas disponibles
3,
b. Opening
the control
knob before turning
on
the LP gas at the cylinder,
Turn on the gas
at the LP cylinder
first before
turning
on a
control
knob to light,
c. Improper
purging
of cylinder
before
it was
filled.
See your
LP gas dealer,
Wind could
be blowing
out your
burner,
Turn
front
of grill to face wind or move
out of the wind.
EXCESSIVE
FLARE-UPS
1.
Heat diffuser,
inside of grill, grates,
and burners
need to be cleaned.
2.
Grease
tray
needs to be cleaned
and emptied.
3.
Using too high of heat to cook.
Reduce control
knob setting.
4.
Direct cooking
method
will produce
more flare-
ups than
indirect,
If using direct
method,
try
using indirect,
FlrRE BEHIND
CONTROL
PANEL
Immediately
shut off cylinder valve
and allow grill to
cool.
1.
Check burner
for obstructions
and clean.
2.
Inspect
under
the control
panel to be sure the
burners
are aligned
properly
with the valves.
1.
Gas is leaking
from a faulty
connection
or
damaged
hose.
Perform
a leak test and inspect
for leaks. Tighten
or replace
parts
as necessary.
Can [ convert
my gas grill from
one fuel source
to
another?
No. Your gas grill is manufactured
to specific
standards
developed
by CSA and ANSI for your
safety
and grilling
performance
for LP Gas. We
do not offer conversion
kits nor do we
recommend
you change
the fuel type.
How are your
grills
tested?
Our grills
are tested
and certified
by CSA, a
leading
worldwide
independent
testing
center,
to meet or exceed
various
CSA and ANSI
standards
along
with various
performance
standards.
The burners
and gas line in each
grill are also individually
tested
when each grill
comes
off the assembly
line just
prior to
packaging.
Each burner
is ignited
for this test.
What
is the
humming
noise
I sometimes
here
coming
from
my regulator?
The humming
sound
you can hear is just
gas
flowing
through
the regulator.
There is no need
to be concerned
with a low volume
of noise.
My grill has a low flame
on some
burners,
or
some burners
will not light at all. What
can cause
this?
This can be caused
by the regulator's
flow
limiting
device,
which
is generated
by a
sudden
change
in pressure.
Opening
the tank
valve too quickly
can cause this. In this case,
close the LP tank valve and disconnect
from
the regulator.
Let it stand
for 10 minutes.
Reconnect
the regulator
to the LP tank.
Open
the grill
lid. Slowly
open the LP tank valve.
Follow the burner
lighting
procedures
and light
the burner
furthest
from the LP tank.
Continue
to light the other
burners
as you move towards
the LP tank.
Can [ use ceramic
plates,
briquettes
of any
kind,
or lava
rocks?
No. Your grill is designed
for use only with heat
diffusers.
Grease
drips down on to the
diffusers
and is burned,
creating
steam
and
additional
flavor.
27
