Idiomas disponibles
Idiomas disponibles
Installation & Mounting:
Before installation, examine the LED beacon for transit damage.
Do not use damaged or broken parts.
Important! This unit is a safety device and it must be connected to its
own separate, fused power point to assure its continued operation should
any other electrical accessory fail.
Mounting:
Mounting:
1.
The EB7180 series LED beacon should be mounted to a
flat surface or one with the least amount of curvature. The
mounting location should allow the maximum visibility of
the warning device to other road users, while allowing for
sufficient wire access.
2.
Using the supplied mounting gasket as a template, mark
the four (4) drill hole locations on the mounting surface.
3.
Drill mounting holes using a #29 (0.136" [3.45mm] dia.) drill
bit.
4.
Drill a 5/16" [8mm] hole for the wires protruding from the
bottom of the unit. Remove any sharp edges from this hole.
5.
Mount the LED beacon along with the mounting gasket,
routing the wires through the 8mm hole and use additional
grommets or cable protection as necessary to protect the
wiring from any sharp edges. Secure the LED beacon to
the surface using the M4x16mm self-tapping screws as
supplied.
Caution: When drilling into any vehicle surface, make sure the area is free
from any electrical wires, fuel lines, vehicle upholstery, etc. that could be
damaged
Wiring Instructions:
Wire functions are as follows:
Black Wire:
Red Wire:
Yellow Wire:
Blue Wire:
Push Time
0-1 Sec.
1-3 Sec
3-5 Sec.
Factory Default(Pattern 1: Single Flash 75 FPM p1)
5- Sec.
920-1025-00 Rev. B
Ground. Connect to either the bat-
tery negative terminal or a suitable
chassis point.
Power. Switch to 12-24V to
operate the beacon. Must be
powered through the fuse, located
as close to the battery terminal as
possible. Use a 5A fuse for single-
stack & a 10A fuse for double-
stack.
Flash pattern set. Touch wire to
Ground momentarily (< 1 sec) to
cycle through the available flash
patterns (see table below).
Sync.
Yellow Wire Function Table
Function
Next Pattern/on
Previous Pattern
OFF
Wiring Instructions in Single Stack
The permanent mount beacon wire functions are as outlined
below:
COLOR FUNCTION
Red Power
Black Ground
Yellow Pattern Switching
Blue Synchronization
Wiring Instructions in Double Stack
The permanent mount beacon wire functions are as outlined
below:
COLOR FUNCTION
Red Power
Black Ground
Yellow Pattern Switching
Blue Synchronization
White Dimming
Wiring Instructions in Double Stack Split Color
The permanent mount beacon wire functions are as outlined
below:
COLOR FUNCTION
Red Power
Black Ground
Purple Top Stack
White Bottom Stack
White + Purple Top & Bottom
Stacks Alternating
Yellow Pattern Switching
Blue Synchronization
CONNECT TO
+VDC
Ground
Touch Ground to change
pattern
Connect blue wires of all
beacons together for
synchronization
CONNECT TO
+VDC
Chassis Ground
Touch ground to change
pattern
Connect blue wires of all
beacons together for
synchronization
Chassis Ground to
Activate
CONNECT TO
+VDC
Chassis Ground
Connect Ground to
Activate (release will be
no activate)
Connect Ground to
Activate (release will be
no activate)
Connect Ground to
Activate
(release will be no
activate)
Chassis Ground to
Activate
Connect blue wires of all
beacons together for
sychronization
Page 2 of 12
