Environmental Protection - Worx WX80RS Traducción De Las Instrucciones Originales

excess vibration or tearing of the metal.
DO NOT force the cutting blade. Forcing the
blade will reduce blade life and cause the
blade to break.
NOTE: We recommend that you spread a thin
film of oil or other coolant along the line of
cut ahead of the saw. This will allow easier
operation and help extend blade life. When
cutting aluminum, use kerosene.
10. POcKET cUTTING (Soft materials
only)
Mark the pocket or internal hole to be cut out.
Insert the special cutting blade with blade
teeth facing down and clamp securely. Angle
the saw so that the back edge of the blade
guard is resting on the work surface (See Fig.
H.1 and Fig. H.2). Use a slow speed to start the
cut to avoid breaking the blade but increase
to correct speed once the cut has started. With
the blade guard held firmly against the work
surface, start a slow but controlled upward
swing of the saw. The blade will cut into and
through the material. Always ensure the blade
is completely through the material before
cutting the remainder of the pocket.
10
WORk HINTS FOR YOUR
RECIPROCATING SAW
If your power tool becomes too hot, set the
speed to maximum and run a no load for 2-3
minutes to cool the motor.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
The blade guard must be held firmly against
the material being cut to reduce saw vibration,
blade jumping and blade breakage.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots
Reciprocating saw
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal. If the supply
cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
EN