Kohler K-1737 Guia De Instalacion página 9

Steam Head
Cable, Data , 72" (182.9 cm)
and
Black, Straight Through
Housing
Assembly
DTV II
DTV II Media Module
Harness, CSM Peripheral
Coupler 3-Way Straight
5. Install the Steam Control - Dual Steam Head Configuration
Remove the adhesive backing from the back of the steam adapter.
Mount the steam adapter firmly to the side panel of the steam generator.
NOTICE: Do not pinch, nail, wedge, or use undue force when handling the silver crossover connector
cable. Any damage may result in adapter kit failure. If the steam adapter kit is not installed immediately,
protect the control cable end with tape or other shielding material.
Connect the silver crossover cable to the steam adapter and the inlet side of the 3-way coupler.
Connect one black straight-through cable to the output side of the 3-way coupler and the first
generator.
Connect the other black straight-through cable to the output side of the 3-way coupler and the
second generator.
Connect the temperature sensor wire to the corresponding port on the steam adapter.
Route the media module cable from the steam adapter to the media module (or peripheral
equipment) and connect at both ends. Refer to and follow the instructions packed with those
devices.
NOTE: If additional equipment is to be connected downstream of this device, remove the terminator and
follow the instructions packed with the additional equipment.
Turn on the water supply.
Restore the power at the main breaker panel.
Turn on the power to the generator.
Kohler Co.
Temperature
Sensor
Drip Loop
Drip Loop
9
Steam Generator Control Cable
Input (location varies by model)
Steam Generator Control Cable
Input (location varies by model)
Cable, Data , 10" (25.4 cm)
Black, Straight Through
Steam Adapter Kit
Cable, Data,
10" (25.4 cm) Silver, Cross-over
1069332-2-C