Campingaz 200 S Instrucciones De Empleo página 4

E - STORAGE - SERVICING
Stove
Ensure that your stove is regularly maintained, and it will
give you many years of excellent service.
- Do not clean the stove while it is in operation. Wait for it
to cool down, to avoid burning yourself on the hot parts
(Saucepan supports, burners).
- The burner cap is accessed by removing the
saucepan support.
- Check that the burner Venturi tubes on the injector are
not obstructed by dust or cobwebs.
- While cleaning, take care not to obstruct the burner
GB
holes. If the holes should be blocked, for example by
food overflow, leave the burner cap in warm water and
unclog the holes using a non-metallic brush.
- Clean the
water or
(Do not use a scouring pad or abrasive products).
- For easier cleaning the pan supports can be washed in
a dishwasher.
- Consider protecting the appliance lid by inserting a
protective material (paper, cardboard, .... ) between the
lid and the pan support and folded windshields.
- Remove and clean all parts of the stove and dry them
well. Store the packed stove in a dry, well-ventilated
place.
Possible problems / Corrective action
The burner does not light up
- Poor gas supply
- Regulator not operating properly
- Pipe, valve, venturi tube or burner holes obstructed.
greasy parts with
a non-abrasive detergent;
The burner does not burn smoothly or goes out
- Check that gas is present
- Check the pipe connection
- Contact your servicing agent.
Unstable blowing flames
- New cylinder may contain air. Allow the stove to operate
and the fault will clear itself
- Residual water, following the washing of the
burner caps
- Contact your servicing agent.
Large plume of flame on the burner surface
- The venturi is obstructed (possibly cobwebs). Clean the
venturi.
- Contact your servicing agent.
soapy
Flame at the Injector
- The cylinder is almost empty
- Change the cylinder and the fault will clear itself
- Contact your servicing agent.
Burning leak around a union
- Shut off the gas supply immediately
- Leaking union: tighten nuts or change pipe
- Contact your servicing agent.
Insufficient heat
- Injector or venturi tube obstructed
- Contact your servicing agent.
Burning leak behind the adjustment knob
- Defective valve
- Shut down the stove
- Contact your servicing agent.
4