CREE LIGHTING ZR Serie Instrucciones De Instalación página 2

3
Junction Box
Cover
AC Wiring
4
Chamber
Dimming Wiring
Chamber
5
6
1
2
DO NOT Rotate
Arrow Marked
End Cap
7
2
2 of 3
End Cap
Arrow Marks
Lens Into This
Zone
1
Fixed End Cap
WIRING AND 0 - 10V DIMMING OPTION
STEP 1:
Remove the screw on the cover of the junction box and bring in
appropriate power supply to the junction box using one of the
knock-outs. See Figure 3 and 4.
STEP 2:
Bring dimming conduit into dimming wire compartment using
one of the knock-outs on the dimming side of the junction box.
See Figure 4 .
STEP 3:
Wire luminaire per "Electrical Connections" section and push
all leads into the junction box. Reattach junction box cover that
was removed in Step 1. Make sure no wires are pinched.
CLEANING LENS
STEP 1:
Locate the end cap with the arrow marks on it, indicating that the
end cap is removable. See Figure 5.
STEP 2:
Grab the lens section next to the end cap and pull lens and end
cap together downward gently until end cap just clears luminaire
(about 3" to 4" from original position). See Figure 6.
STEP 3:
Disengage the other end of the lens from the opposite end cap
by pulling lens away from end cap. See Figure 6. Once lens is
removed, perform cleaning.
STEP 4:
After cleaning is complete insert lens back into fixed end cap.
Push the removable end cap upward into the housing and using
a gentle rocking motion engage the end cap to retention clip.
Check removable end cap for any visible gap between the end
cap and end panel. If necessary push end cap against the end
panel to eliminate gaps.
Check lens for any visible gap between the lens and luminaire.
If necessary push lens upward at gap location to seal magnetic
foam to luminaire. See Figure 7.
LPN00678X0001A0_A