Leckey Tour Mobility Base Instrucciones Para El Usuario página 9

To mount the Mygo Seating System on the
mobility base first release the safety locking
pin at the front of the seat. To do this pull
the pin out and rotate through 90 degrees.
Carefully lift the seat and place it into the
chassis. At the rear of the underside of the
seat you will see a receiving channel. Place
this securely over the tube towards the back
of the chassis. Pull the handle at the front
of the seat unit up and then pivot the seat
forward and down. Once the front of the
seat is lowered fully, release the handle and
push it forward to ensure it has fully engaged
on the front tube. Rotate the safety locking
pin so it engages in front of the handle. If it
hits the handle then the seat is not inserted
properly. Remove and repeat process
outlined above.
A
Once the seat is mounted, ensure that the
static stability of the product is checked. If
the stability is less than 10˚ the user and/
or attendant need to be informed using a
clear warning note, to allow them to take
precautions in interest of the user's safety.