Axis Q60 Serie Guia De Instalacion página 19

AXIS Q60 Series
2. Install the mounting plate. The arrow on the mounting plate will align with the logotype
on the camera.
1
Mounting plate
2
Safety wire
3. Loosen the camera base lid screws and remove the camera base lid.
4. Secure the camera using the supplied safety wire.
5. Route and connect the network cable and the multi-connector cable (sold separately), if
applicable, to the camera.
NOTICE
NOTICE NOTICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks and, if applicable,
remove the cut-out piece for the multi-connector cable from the foam gasket.
1
Cable holders
2
Multi-connector cable (sold separately)
3
Network cable (not included)
6. Turn the cable holders to keep the cables in place.
7. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
2
19
1
1
2
3