Delta 44 Serie Manual Del Usuario
  1. Manuales
  2. Marcas
  3. Delta Manuales
  4. Equipo Industrial
  5. 44 Serie
  6. Manual del usuario
Delta 44 Serie Manual Del Usuario

Delta 44 Serie Manual Del Usuario

Ocultar thumbs
1
2
3
4
5
6
7
8
Tabla de contenido

Enlaces rápidos

®
ASME A112.18.1 / CSA B125.1
Models/Modelos/Modèles
44 Series/Serias/Seria
Write purchased model number here.
Escriba aquí el número del modelo comprado.
Inscrivez le numéro de modèle ici.
For easy installation of your Delta
faucet you will need:
• To READ ALL the instructions completely
before beginning.
• To READ ALL warnings, care, and maintenance
information.
• To purchase the correct water supply hook-up.
Para instalación fácil de su llave Delta
usted necesitará:
• LEER TODAS las instrucciones completamente
antes de empezar.
• LEER TODOS los avisos, cuidados, e
información de mantenimiento.
• Comprar las conexiones correctas para el
suministro de agua.
Pour installer votre robinet Delta
facilement, vous devez:
• LIRE TOUTES les instructions avant de
débuter;
• LIRE TOUS les avertissements ainsi que toutes
les instructions de nettoyage et d'entretien;
• Acheter le bon nécessaire de raccordement.
11/15/08
Rev. C
U P
C
®
THREE HANDLE ROSETTE BIDET
VALVE WITH VACUUM BREAKER
AND POP-UP ASSEMBLY
VÁLVULA DE TRES MANIJAS PARA EL
BIDÉ DE BOQUILLA ROCIADORA CON
ROMPEDOR DE VACÍO Y ENSAMBLE
DEL DESAGÜE AUTOMÁTICO
ROBINET À TROIS POIGNÉES POUR
BIDET AVEC AJUTAGE, CASSE-VIDE
ET RENVOI MÉCANIQUE
You may need/Usted puede necesitar/
Articles dont vous pouvez avoir besoin:
1
3/32" (2.38mm)
3/32 po (2.38mm)
L
Tabla de contenido
loading

Manuales relacionados para Delta 44 Serie

Resumen de contenidos para Delta 44 Serie

  • Página 1 • To READ ALL the instructions completely before beginning. • To READ ALL warnings, care, and maintenance information. • To purchase the correct water supply hook-up. Para instalación fácil de su llave Delta usted necesitará: • LEER TODAS las instrucciones completamente antes de empezar. 3/32" (2.38mm) 3/32 po (2.38mm)

  • Página 2: Cleaning And Care

    MAKE ANY OTHER WARRANTY OF ANY KIND, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY. Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use & service. Replacement This warranty excludes all industrial, commercial &...
  • Página 3 LSpecify Finish/Especifíque el Acabado/Précisez le Fini RP6060, RP6060SB Bonnets/Bonetes/ Chapeaux RP13740L Vacuum Breaker Assy. RP10965 L Ensamble del Rompedor de Vacio Base w/Gasket Casse-Vide Base con Empaque Base avec Joint RP10092L Base w/ Gasket RP24097 Base con Empaque 1/4 Turn Stop Base avec Joint Tope a un 1/4 de Giración Butée 1/4 de Tour...

  • Página 4: Installation Instructions

    RP18429L RP18373L RP5885 RP5885 6" Min. 6 po Min. RP26865 RP20185 RP26865 RP26865 RP20185 RP20185 INSTALLATION INSTRUCTIONS (Refer to page 3) SHUT OFF WATER SUPPLIES 1. Remove upper cone washer from directional valve assembly (1), and place assembly in bidet from bottom. Replace cone washer. Place gasket, then RP26865 base, (2) on directional valve and tighten base until flush with top of threaded shoulder.
  • Página 5 METAL POP-UP Remove stopper (1) and flange (2). Apply silicone to underside of flange (1). Insert Remove pivot nut (1). Install horizontal rod body (2) into sink. Screw flange (1) into body (2). (2) and stopper (3) as removable (4) or non- removable (5).
  • Página 6 1/2" (12.70mm) IPS 1/2 po (12.70mm) IPS INSTALL HANDLES: MAKE CONNECTIONS TO WATER LINES: If you are installing cross or lever handles, be sure to install Note: Be careful when bending the copper tubing. Kinked the retention screws (1) into the stems prior to installing tubes will void the warranty.

  • Página 7: Instrucciones Para Operacion

    OPERATING INSTRUCTIONS FLUSH YOUR SYSTEM 1. Check to be sure the diverter valve (center handle) is in the rim feed position (turned fully clockwise). After connections have been made, turn diverter valve 2. Turn on hot and cold water valves and adjust for desired temperature. (center handle) clockwise to the rim feed position.
  • Página 8 MAINTENANCE Bidet leaks from Rosette Spray: If Bidet exhibits very low flow: SHUT OFF WATER SUPPLIES. Replace Seats & Springs (1). SHUT OFF WATER SUPPLIES. Clean Seats and Springs (1) of any debris. If leak persists: SHUT OFF WATER SUPPLIES. Replace Stem Unit Assembly (2). Install stems (2) and 1/4 turn stops (3) correctly for proper handle rotation.

Tabla de contenido