Vimar Elvox ECF4 Manual De Instrucciones página 5

3.4. ADJUSTMENT RELAY TRIMMER
The device is fitted with a trimmer (TIME) for adjusting the relay activation time. The time range is from 10 to 200 se-
conds (it increases clockwise). Example of setting the work time with respect to the trimmer position:
T=15" T=25"
3.5. RADIO RECEIVER
The circuit board is equipped with a 433MHz radio receiver. On recognition of a radio code, the corresponding relay is
activated. Push-button 1 activates output 1, push-button 2 activates output 2 and so on. If the DIP switches are set,
the relays are activated for the time programmed using the trimmer.
3.6. RADIO CODE PROGRAMMING
Radio code programming is by means of a self-learning system.
To program the radio control codes, press the MEMO (MEM) key, wait until the green LED illuminates then release it.
At this point the device is in radio control programming mode. Press the key of the radio control that you want to store.
The green LED will blink and stands by for another code. If you try to store a code which is already stored, the device
exits programming mode.
3.7. EXIT FROM RADIO CODE PROGRAMMING
The card exits radio code programming mode if no codes are received for about 10 seconds, if you try to store a code
which is already stored.
3.8. DELETING ALL RADIO CODES
To delete the radio codes, proceed as follows: Press the MEMO (MEM) key, and keep the MEMO key pressed until the
green LED illuminates. Now release the "MEM" key and press it again. the green LED blinks at a certain frequency. Re-
lease the key and press it again. At this point all of the radio codes are deleted.
ECF4
T=40" T=80"
5/16
T=150" step by step
GB