Installing The Wmxc-Series Wall Mount; Wiring The Non-Supervised Dc Beacon To The Wmxc-Sb; Figure 3 Model Wmxc-Sb Wall Mount - Federal Signal CMXC-SB Serie Instrucciones De Instalación

Installation Instructions for Optional Fixture Mounts
Installing the WMXC Series Wall Mount
To install the wall mount fixture on the support surface:
1. See Figure 3. Secure the wall mount to the support surface
using the two external mounting holes.
2. Use wire nuts to connect power and ground as described in the
next sections.
Wiring the Non-supervised DC Beacon
to the WMXC-SB
SHOCK HAZARD—To avoid electrical shock hazards, do not
connect the light to the supply circuit when power is applied.
REVERSE POLARITY/MISWIRING—DC strobe units are
polarity- and voltage-sensitive and may be damaged by an
incorrect electrical hookup. When connecting the 24 Vdc
strobe unit to the voltage supply lines, polarity must be
observed. In addition, damage will result if the voltage rating
of the particular model is exceeded.
Models CMXC-SB, PMXC-SB, and WMXC Series
10

Figure 3 Model WMXC-SB wall mount

INSPECTION HOLE
CLOSE-UP PLUG
290A7245