SATA AE5602T Manual Del Uso página 58

中文
AE5602T
EN DE RU KO PT JA ES
2.3.3Clamps Installation
The center of the clamps has been locked by taper pins before leaving factory. No need center adjustment
anymore. Rotate hand wheel to fit claw to diameter of hub. (as picture 4). the handle of clamp must be upward and
vertical to ground. Four positioning sides must be close to hub rim. Rotate hand wheel again to fix clamp on hub
firmly. Shake it by hand to check if it is fixed well.
Caution:To avoid claws falling, please fix clamp on hub by protection cover.
• two-dimensional diagram and photo as follows:
58