INSTALLATION INSTRUCTIONS
AXIS 72 x 42 NEO ANGLE SHOWER DOOR
MODEL: AM4242N3400C SERIES
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
GENERAL INFORMATION
Please inspect the product immediately upon receipt for transit damage, missing packs/parts or manufacturing
fault. Damage reported later cannot be accepted. Please handle the product with care avoiding knocks and
shocks, or loading to all sides and edges of the glass.
IMPORTANT: TEMPERED GLASS CANNOT BE DRILLED, CUT OR MODIFIED.
READ THE INSTRUCTIONS CAREFULLY
Familiarize yourself with all the parts as shown in the assembly drawing. The assembly drawing will also
provide a helpful reference when relating the location of the various parts and how they are mounted.
Special care should be taken when drilling walls to avoid hidden pipes or electrical cables.
Note: This product is heavy and requires two people for a portion of the installation.
For product quality or installation issues, we would like to hear from you. Please don't hesitate to call
American Standard at 800-442-1902 and follow the prompts for consumer/shower doors.
AFTER-CARE INSTRUCTIONS
After use, your shower should be cleaned with soap and water. This is particularly important in hard water
districts where insoluble lime salts may be deposited and allowed to build up. Cleaners of a gritty or abrasive
nature should not be used. Care should be taken to avoid contact with strong chemicals such as organic
solvents and strippers.
Glass cleaners can be used, but with caution; if in doubt, contact the manufacturer of the cleaner in question.
Please keep these instructions for aftercare and customer service details.
Caulking Gun & Silicone
Safety Glasses
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2016
REQUIRED TOOLS AND MATERIALS
Drill
Regular Screwdriver
Phillips Screwdriver
1/4" & 1/8" Drill Bits
Tape Measure
#2 Square Drive Bit
Pencil
Hammer
1
10'
Painter's
Masking Tape
Utility Knife
7 10 3 54 - 10 0 Rev. A 8 /16
Level