Operational Modes - Campbell Hausfeld NS219001 Instrucciones De Operación

Operating Instructions
4. Carefully
place no-
mar tip
over the
end of
work
contact Grooves
element.
Position
tip onto
WCE
making certain serrated gooves on
each piece are in line and fit snugly
together.
5. Position
retaining
ring on no-
mar tip and
press firmly
in place.
6. Check
that the
WCE and
trigger
move up
and down
freely
without
sticking or
binding.

Operational Modes

operational mode of the nailer before
using. Failure to know the operational
mode could result in death or serious
personal injury.
This stick framing nailer may be
operated in the "Single Cycle" or the
"Bottom Trip" mode. The nailer is
delivered in the single cycle mode. A
separate 'red' trigger for "Bottom
Trip" mode is included with tool as an
accessory.
SINGLE CYCLE MODE
When the black trigger is installed,
nailer is in single cycle mode. This
method is recommended when precise
nail placement is required. Operation
in this mode requires trigger to be
pulled each time a nail is driven. Nailer
can be actuated by depressing the
Work Contact Element (WCE) against
work surface followed by pulling the
trigger.
The trigger must be released after each
fastener is driven to allow tool to reset.
Since the tool can only be actuated by
first removing the finger from the
trigger, this is considered to be a more
restrictive mode of operation, suitable
for less experienced users.
www.chpower.com
BOTTOM TRIP MODE
When the red trigger is installed, the
nailer is in bottom trip mode. This
method is recommended when less
precise nail placement is required.
Operation in this mode requires trigger
to be depressed with nailer off of the
work surface. Then, the nose of the
nailer is tapped against the work
surface causing a nail to be driven.
Each time the Work Contact Element is
depressed, a nail is driven into the work
surface. Extreme care should be taken
because a nail will be driven when the
WCE is pressed against any surface.
Since the tool can be actuated without
removing the finger from the trigger,
this is considered to be a less restrictive
mode, suitable for more experienced
users.
MODE CONVERSION
To convert the tool from one mode to
the other:
1. Remove o-ring on the side of
trigger pin.
2. Remove trigger pin, trigger, and
trigger spring.
3. Switch out only the trigger.
4. Replace trigger spring, trigger,
trigger pin, and o-ring.
Do not attempt to modify the trigger
components in any manner and do not
attempt to use any other trigger
Always
components other than those intended
know the
for this tool.
Contact your Campbell Hausfeld
representative if you have any
questions.
Mode Conversion
Trigger spring
O-ring
Trigger
Trigger pin
4
WORK CONTACT ELEMENT (WCE)
operation of the Work Contact Element
(WCE) trip mechanism before each use.
The WCE must move freely without
binding through its entire travel
distance. The WCE spring must return
the WCE to its fully extended position
after being depressed. Do not operate
the nailer if the WCE trip mechanism is
not operating properly. Personal injury
may occur.
1. Disconnect
the air
supply
from the
nailer.
2. Remove all
nails from the
magazine
(see
Unloading
The Nailer).
3. Make
sure the
trigger
and work
contact
element
(WCE)
move
freely up
and
down without sticking or binding.
4. Reconnect
air supply to
the nailer.
5. Depress the
Work
Contact
Element
(WCE)
against the
work surface
without
pulling the
trigger. The
nailer MUST NOT OPERATE. Do not
use the tool if it operates without
pulling the trigger. Personal injury
may result.
Check
the