SATA AE5603 Manual Del Uso página 45

AE5603
EN DE RU KO PT JA ES
2.4.2 Selection of claws on clamp
1. outward :
When radian of hub rim is large, adopt positioning of claws like picture Two.Four claw ends must be close to hub rim.
2. inward :
Generally only small round ends on hub rim without radian, adoptpositioning of claws like picture Three. Four claw ends
must be close to hubrim.
wheel hub
(Pic 3)
(Fig. 3)
Rim of hub is close to ends of claw
2.3.3 Clamps Installation
The center of the clamps has been locked by taper pins before leavingfactory. No need center adjustment anymore. Rotate
hand wheel to fit clawto diameter of hub. (as picture 4). the handle of clamp must be upward andvertical to ground. Four
positioning sides must be close to hub rim. Rotate hand wheel again to fix clamp on hub firmly. Shake it by hand to check if
it is fixed well.
(Pic 4)
wheel hub
43
- 03 -