Idiomas disponibles
Idiomas disponibles
( ( 2 2 6 6 ) ) H H i i g g h h 2 2 B B a a n n d d L L e e v v e e l l C C o o n n t t r r o o l l
Each band-pass section features a level control to compensate for the various loudspeaker efficiency ratings.
The HIGH 2 Level has +/-20dB range and unity gain (default) at the center detent position. In Mono MODE,
HIGH 2 is the only HIGH level control.
( ( 2 2 7 7 ) ) C C D D H H o o r r n n E E Q Q B B o o o o s s t t
Adjusts the amount of boost within the HIGH band to compensate for the frequency roll-off and lost of
efficiency with some compression drivers. The screwdriver shaft control provides a variable boost from 0 dB to
+12 dB at 20 kHz, with first-order slop and excellent phase response.
( ( 2 2 8 8 ) ) H H i i g g h h 2 2 P P o o l l a a r r i i t t y y S S w w i i t t c c h h
When engaged‚ reverses the polarity of the signal in the HIGH 2 frequency band to speed up trouble shooting
and assure proper phase response of the audio system.
( ( 2 2 9 9 ) ) S S i i g g n n a a l l P P r r e e s s e e n n t t L L E E D D
This green LED indicates the presence of a signal higher than -22 dBu in the HIGH 2-band even if the band is
muted.
( ( 3 3 0 0 ) ) H H i i g g h h 2 2 M M u u t t e e S S w w i i t t c c h h
When engaged eliminates the signal in the HIGH 2 band, to help during installation of the audio system.
( ( 3 3 1 1 ) ) C C l l i i p p / / M M u u t t e e L L E E D D
This red LED indicates when the signal level in the HIGH 2 frequency band is approaching the maximum
available headroom of +22 dBu. It illuminates when the band signal reaches approximately +20 dBu. In Mute
mode this LED illuminates continuously.
( ( 3 3 2 2 ) ) P P o o w w e e r r S S w w i i t t c c h h
Toggle this push-button to turn the unit ON or OFF.
( ( 3 3 3 3 ) ) P P o o w w e e r r L L E E D D
This blue LED illuminates when the VSXII is powered on.
O O p p e e r r a a t t i i o o n n N N o o t t e e
Always check for proper system connections before applying power. Upon initial hook-up, mute all
bands and set all the band-pass level controls to minimum (-20 dB) position before applying power;
then slowly bring up the various levels to verify proper band-pass connections. An improperly wired
system could destroy loudspeakers.
8
