Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PEDESTAL AND CONSOLE LAVATORY INSTALLATION
1
Wall Preparation for Sink and Pedestal/Console Installation
Provide suitable 2x6 reinforcement behind nished wall for Console or Sink
mounting screws.
Note: If replacing an existing sink be certain to shut off water supply prior
to removing old sink.
2
Preparation of Sink and Pedestal/Console
1.
Place pedestal/console into approximate position near wall.
2. Place sink on pedestal/console, [NOTE: If placing sink on console, use provided square silicone pads and rubber bumpers over
each corner] aligning recesses on the underside of the sink to the respective location on pedestal/console.
3. Place a level on the sink and pedestal/console assembly.
4. If leveling sink on the Console, use the adjustable feet on the bottom of each leg.
5. Move sink and pedestal/console assembly into contact with wall.
6. With a pencil, mark through the center of the two mounting holes found on the back of the sink and two additional holes on the back
of the console if using the console. (If securing pedestal to oor, mark the center of holes on the bottom of the pedestal.)
Top of Console
Silicon Sink
Mounting Pads and
Rubber Bumpers
C/L of 2 x 6
Reinforcement
Top of Pedestal
3
30-3/4"
(781mm)
Finished
Floor
Example rubber
bumper locations
to raise the left
side of the sink.
7302364-100 Rev. 2 (3/19)
Tabla de contenido
