Programme End; Temperature Selection - Hoover H-WASH 500 Manual De Instrucciones

Moreover, If you want to modify the

chosen programme, press the desired
options buttons,
parameters and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
After switching on the appliance, wait a

few seconds for the programme to start
running.
PROGRAMME DURATION
When a programme is selected the

display automatically shows the cycle
duration, which can vary, depending on
the options selected.
Once the programme has started you will

be kept informed constantly of the time
remaining to the end of the wash.
The appliance calculates the time to the

end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.

PROGRAMME END

When the display

programme is finished and the DOOR
LOCKED indicator light has gone out, the
door can be opened.
At the end of the cycle, switch off the

appliance by turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
modify the default
shows that the
PAUSING THE MACHINE
Keep the START/PAUSE button pressed

for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, set the

selector to the OFF position.
Wait until the DOOR LOCKED light has

gone out before opening the door.

TEMPERATURE SELECTION

button
This button allows you to change the

temperature of the wash cycles.
It is not possible to raise the temperature

over the maximum allowed for the
programme, in order to protect the
fabrics.
If you want carry out a cold wash all the

indicators must be off.
SPIN SPEED button
By pressing this button, it is possible to

reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
If the label does not indicate specific

information, it is possible to use the
maximum spin expected in the program.
72