Back View - peerless-AV CM850 Instalación Y Montaje

11
Roll can be adjusted 1° clockwise or
counterclockwise.
To adjust roll, loosen M10 x 15 mm screws (I)
slightly, leaving them snug. Level display and
adapter brackets, then tighten screws (I) .
NOTE: When adjusting roll, screws should be
retightened as indicated in step 8.
M10 x 15 MM SCREW (I)

BACK VIEW

13
Optional: To lock one sliding arm of mount in place,
slide locking tab (H) over top or bottom of sliding
arm and attach to mount using one M5 x 10 mm
screw (M) and one spacer (N).
NOTE: Full assembly/display not shown for clarity.
Visit the Peerless Web Site at www.peerless-av.com
NOTE: MOUNTING PLATE SHOW
WITHOUT FULL WALL MOUNT
ASSEMBLY FOR CLARITY.
SLIDING ARM
12
Optional: To lock mount in closed position, insert
one M5 x 40 mm screw (L) into tapped hole in either
top or bottom of fl at plate.
NOTE: Full assembly/display not shown for clarity.
TAPPED HOLE
14
Slide one mesh sleeve (R) over each cable. Use
cable ties (O) to tighten both ends of mesh sleeves
to cables.
NOTE: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
M
H
N
15 of 48
ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)
L
TAPPED HOLE
FLAT
PLATE
R
CABLE
MOUNTS
O
For customer care call 1-800-865-2112