peerless-AV CM850 Instalación Y Montaje página 13

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

For Flat Back Display
8-1
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
8-2
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
Visit the Peerless Web Site at www.peerless-av.com
DISPLAY
ADAPTER
BRACKET
DISPLAY
SPACER
13 of 48
fi g. 8.1
MULTI-WASHER
SCREW
(F)
fi g. 8.2
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(F)
ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)
For customer care call 1-800-865-2112
Tabla de contenido
loading

Este manual también es adecuado para:

Cm850-s

Tabla de contenido