peerless-AV CM850 Instalación Y Montaje página 14

• Always use an assistant or mechanical lifting equipment to safely lift and position the plasma television.
Mounting and Removing Flat Panel Display
9
Hook adapter brackets (F) onto adapter plate (D), then slowly swing display in as shown. Turn screws clockwise
at least six times to prevent display from being removed as shown in detail 1. Tighten using 4 mm security allen
wrench (T).
Display can be adjusted horizontally if desired.
NOTE: To lock the display down, tighten screws to adapter plate as shown in detail 1.
To remove display from mount, loosen screws, swing display away from mount, and lift display off of mount.
SCREWS
10
Display can tilt 5° or 10° forward.
NOTE: Display must be securely attached to mounting plate with all fasteners before adjusting tilt.
To tilt display 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in
fi gure 10.1. Tighten M6 screw (both sides) and M10 screws (both sides).
To tilt display 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in fi gure
10.2. Tighten M6 screw (both sides) and M10 screws (both sides).
NOTE: For security models, tighten M6 screw using security allen wrench (T). For all M10 screws, use 6 mm allen
wrench (not included).
DISPLAY
fi g. 10.1
Visit the Peerless Web Site at www.peerless-av.com
D
DETAIL 1
M6 SCREW
MOUNTING
PLATE
M10 SCREW
5° tilt
WARNING
F
DISPLAY
fi g. 10.2
14 of 48
D
M6 SCREW
MOUNTING
PLATE
M10 SCREW
10° tilt
ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)
For customer care call 1-800-865-2112