Installing Adapter Brackets - peerless-AV CM850 Instalación Y Montaje

Installing Adapter Brackets

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
8
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
display face side down. Refer to display manufacturer's instructions or customer service, for removing any knobs,
base, cover, or screw(s) on the back of the display to prepare mounting. These need to be removed to allow the
adapter brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener
pack then attach adapter brackets (F) to display following fi gure 8.1 or 8.2.
NOTE: Top and bottom mounting holes on display must be used for attaching brackets. Verify that all holes are
properly aligned, and then tighten screws using a phillips screwdriver.
MULTI-WASHER
NOTE: For fl at back displays proceed to step 8-1. For bump-out or recessed back display skip to step 8-2.
Visit the Peerless Web Site at www.peerless-av.com
F
Note: "X" dimensions should be equal.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
WARNING
CENTER BRACKETS
VERTICALLY ON BACK OF
DISPLAY
Notes:
• The number of fasteners used will vary,
depending upon the type of display.
• Multi-washers and spacers may not be
used, depending upon the type of display.
• Use the corresponding hole in the multi-
washer that matches your screw size.
12 of 48
X
X
ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)
For customer care call 1-800-865-2112