Important Considerations; Manual Mode - Heath Zenith 5846 Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

2. Turn the control dial to the TEST position (see Figure 5). Note:

When the control dial is set to the TEST position, the light fixture

will operate during the day or night. The light will stay on for 8

seconds after all motion has stopped.

3. Walk through the coverage area noting where you are when the

lights turn on. Also, the red LED behind the motion sensor lens

will flash several times when motion is detected (see Figure 6).

4. Stop, wait for the light to turn off, and then begin walking again.

Continue this process until the detection zone has been established.

5. If needed, gently grasp the motion sensor and move it from side

to side or up and down to adjust the detection zone.

6. If needed, gently grasp the lamp heads and move them from side

to side or up and down to adjust the light coverage area.

7. Turn the control dial to set the amount of time you want the

lights to stay on after all motion has stopped (adjustble between

5 seconds and 5 minutes) (see Figure 7). Note: When set between

5 seconds and 5 minutes, the light fixture will only work after

dark (sunset).

AVOID AIMING THE SENSOR AT:

• Below are examples of objects that might produce heat and may cause the motion sensor to trigger:

• Pools of Water

• Animals

• Areas where pets or traffic may trigger the motion sensor.

• Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the

motion sensor.

SEASONAL CHANGES:

The motion sensor works by sensing temperature changes across its field of view. The closer the surrounding temperature

is to a person's body heat, the less sensitive the sensor will appear. The greater the temperature difference, the more sensi-

tive the sensor will appear. This is a normal part of the light sensor's operation.

Manual mode overrides the motion sensor and timer control so the light will

operate full bright. This feature only works at night and only for one night

at a time. The motion sensor will reset to motion sensing mode at 6 hours

or sunrise, whichever comes first. Manual mode can be toggled on and off

using a wall switch.

• To turn manual mode on, switch the light off at the wall switch for 2 to 4

seconds and then back on.

• To turn manual mode off, switch the light off at the wall switch for 2 to 4

seconds and then back on.