Idiomas disponibles
Idiomas disponibles
• While holding spindle 2 with open spanner 9, tighten
fixing nut 1 with another open spanner 9 (when remov-
ing do not tighten fixing nut 1)�
Do not tighten the clamp nut 1 without
grinding tools.
Initial operating
of the power tool
Always use the correct supply voltage: the power sup-
ply voltage must match the information quoted on the
power tool identification plate.
Switching the power
tool on / off
Switching on:
Slide the on / off switch 5 forward without pressing�
Switching off:
Push the back part of on / off switch 5�
Design features
of the power tool
Speed selector thumbwheel
Using revolution adjustment switch 6, you may select
the required spindle speed (also during operation)�
The required speed is dependent on the material and
can be determined with practical trials�
After longer periods of working at low speed, allow the
machine to cool by running for approx� 3 minutes at
maximum speed with no load.
Recommendations
on the power tool operation
Before starting operation switch on your
tool for testing, if the grinding attach-
ments are well fixed and to make sure,
that there is no radial grinding attachment
run - out. If the radial run - out is detected, switch your
power tool off and replace the faulty attachment.
• Switch your power tool on, wait for the spindle to
reach maximum speed and only then start getting the
grinding surface close to the blank treated�
• Best grinding results are achieved, when the power
tool is moved smoothly, while being slightly pressed on�
• Avoid applying excessive pressure on your power
tool, as it will not produce better results, but will over-
load the motor and lead to a quicker grinding attach-
ment wear-out�
The manufacturer reserves the possibility to introduce changes.
• Never use the grinding attachments, which are worn
out in a non - uniform way�
• Grinding attachment defects (deviation in cylindrical
form, non - uniform wear - out, etc�) may be corrected
with honing stick 8� Caution: never attempt to cor-
rect radial grinding attachment run-out with hon-
ing stick 8.
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� During the
long treatment of metal, current - conducting dust can
be accumulated inside the power tool. Regularly flush
the power tool with compressed air thought the ventila-
tion slots 4�
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
•
Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle
disposing as waste.
Power tool, accessories and packaging
should be sorted for environment - friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
18
Transportation
of the power tools
Environmental
protection
raw
materials
instead
of
