Switching Off The Appliance; Cleaning And Maintenance; Emptying The Recovery Tank; Daily Cleaning - Ghibli & Wirbel INPUMP 90.2SP CF Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968

Switching off the appliance

- Push the switches (20-21 Fig. 13) to the
"0" position to stop the device.
- Remove the plug (19 Fig. 12) from the
electrical socket.
- Roll up the cable (22 Fig. 14) and place it
on the cover head.
- Remove the power plug (1 Fig. 1) for the
evacuation pump.
- Release the levers (2 Fig. 2) and remove
the cover (3 Fig. 3) including the motor
unit.
- From the inside the tank, pull the cable
(23 Fig. 15) until the evacuation pump
power plug fits into its slot (24 Fig. 15).
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance
operation, unplug the appliance from the
electrical socket.

Emptying the recovery tank

- Release the discharge hose (25 Fig. 16)
from its base.
- Unscrew the knob (26 Fig. 16), remove
the cap (27 Fig. 16) of the discharge hose
(25 Fig. 16) and drain the liquid inside the
recovery tank (28 Fig. 16).

Daily cleaning

Check and clean mesh filter
- Remove the cover head as described
above.
- Remove the mesh filter (4 Fig. 4).
- Open the filter (4 Fig. 17) by pulling out
the sliding lock (29 Fig. 17), rinse it and
remove any solid residue, then close the
filter again with the sliding lock (29 Fig.
17) and put it back as described before-
hand.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Cleaning the appliance
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the cover head as previously in-
dicated and clean the inside of the tank
from the residues of dirt with running
water, as they can interfere with the op-
eration, and then drain it, by starting the
evacuation pump in order to clean both
the pump and the discharge pipe.
Replace everything doing the opposite of
the disassembly.
NOTES:
Clean the start float (30 Fig. 18) checking
that it slides without difficulty.
DANGER:
Do not wash the appliance using jets of
water.
Periodic checks
Checking the floater
- Remove the top as shown above.
- Check If the floater (31 Fig. 19) is in
good condition and if it moves freely in its
space.
ENGLISH - 3