Switching Off The Appliance; Cleaning And Maintenance - Ghibli & Wirbel M9 Uso Y Mantenimiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
EN
IT
Single motor
-
Push the switch (31 Fig.20) on "I" to start
the suction motor; the switch lights up.
Double motor
-
Depending on the power required it is
possible to start only one motor by press-
ing the switch (32 Fig.20) on "I" or both
switches (32 and 33 Fig. 20) if a greater
suction force is required.
When the switch pressed the correspond-
ing button lights up.
-
For extraction washing, press the switch
(34 Fig.20) on "I" to start the detergent
pump; the switch lights up.
Washing fabrics/carpets
(Extraction washing)
NOTE:
The suction motor and the detergent pump
operate independently; therefore, it is pos-
sible to:
-
wash fabrics or floors/carpets by starting
only the detergent pump;
-
wash and suction liquid simultaneously
by starting up the detergent pump and
suction motor at the same time;
-
suction liquids by only starting the suction
motor.
-
Start suction and the detergent pump by
pressing the relative switches (31 - 34
Fig.20) or (32 - 33 - 34 Fig. 20) depend-
ing on the model.
-
Place the nozzle (22 Fig. 21) on the fab-
ric pressing slightly then press the lever
(35 Fig.21), to dispense the detergent,
release to stop dispensing.
-
The detergent released cleans the fabrics
or the carpet and the dirty liquid is suc-
tioned into the tank of the appliance.
For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs.

Switching off the appliance

-
Press the switches (31 - 34 Fig.20) o (32
- 33 - 34 Fig. 20) to "0" to switch off the
appliance; the lamps on the switches will
go out.
-
Remove the plug (30 Fig.19) from the
socket.
-
Wind up the cable (36 Fig.16) and hook it
onto its housing (37 Fig.16).
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance op-
eration, unplug the appliance from the
electrical socket.
Removing and replacing the paper
dust collection bag (if present)
Release the levers (1 Fig. 1) and remove the
cover (2 Fig. 2) complete with motor.
-
Remove the polyester filter (3 Fig. 3).
-
Remove the paper dust collection bag (4
Fig. 3) and close it with the cap (5 Fig. 4)
and replace it as previously indicated.
-
Reassemble all the parts by following the
dismantling process steps in the reverse
order.
EN - 8
Tabla de contenido
loading

Este manual también es adecuado para:

M9 autoM12 autoCe 35/1 iCe 56/2 i

Tabla de contenido