Control Panel Installation; Box Installation And Cables - Cofem ZafirCO ZCO2 Manual De Instrucciones

Addressable Control Panel for CO and NO
2
ZafirCO
4

Control panel installation

4.1

Box installation and cables

The control panel is based on a rectangular metal box, a label holder on the front, which pivots
on the left side of the box like a door and held closed with a screw located on the right side, and
a separate plastic door seated on the control panel, fixed with four screws at the corners.
The control panel is fixed on vertical surface. Lateral grooves must be free for proper heat
dissipation. The following figure shows the subsequent opening for cable entry of 240 x 40 mm
(A), the 2 predrilling of 28 mm for cable entry (B) on the upper side and lower side (in case
necessary to use additional inputs), and the holes in the bottom of the box for fixing to the
control panel to vertical face (7 mm lower and R5 / R4 upper).
B
A
C
B
Figure 4: Holes for fixing box and passing wires
31
FIRE PROTECTION MANUFACTURER
Ctra. de Molins de Rei a Rubí, Km. 8,4 - 08191 RUBÍ (Barcelona) ESPAÑA.
Tlf.: +34 935 862 690 - Fax:+34 936 999 261 - [email protected] - www.cofem.com