View Events In The Display - Cofem ZafirCO ZCO2 Manual De Instrucciones

8

View events in the display.

In addition to the direct indication of events through the leds of the control panel (see Chapter
6), the control unit allows to obtain detailed information about events through the display and
the possibility of reset some of them.
Pressing the ENTER key on the control panel show the different events in the display arranged
in levels according to the importance of them: ALARMS, FAULTS and TEST.
Within each of these screens, the user can view each event using the arrow keys "up and down"
and with the right cursor has access to more information about it.
The events of the same type always display in chronological order. On screen it is shown a
maximum of two events. In the bottom it is displayed the last event, and in the top, it is the
selected event which can be changed with the up and down cursor keys.
To change kind of events, it is necessary to press ENTER key. For making a reset in the event,
it is necessary to press RESET key.
8.1 Alarms
If an alarm occurs, the control panel lights red alarm Led (F in Figure 10) and the buzzer
sounds.
To view the information on the display, it must be pressed the ENTER key. In order to select
between the different alarms, it must be used the cursor up and down. The first alarm line
corresponds to the selected alarm, while the second field refers to the last alarm received
A L A R M S
0 1 > L A B E L
Pressing right cursor key, it can be seen additional information.
A L A R M S
0 1 > Z : 0 1
40
Ctra. de Molins de Rei a Rubí, Km. 8,4 - 08191 RUBÍ (Barcelona) ESPAÑA.
Tlf.: +34 935 862 690 - Fax:+34 936 999 261 - [email protected] - www.cofem.com
Addressable Control Panel for CO and NO
Figure 11: Keys for viewing events in the display
L A B E L
FIRE PROTECTION MANUFACTURER
ZafirCO
T Y P E :
S C O
< < 0 1 ⁄ 0 2
2
.
0 1 ⁄ 0 1
Point
P t :
0 0 6