Operation - Thermador HDDW 36DS Manual De Uso Y Cuidado

IMPORTANT: The most effective method of removing
vapors produced during cooking is to:
Switch the ventilator ON
prior to cooking or as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished cooking.
Display for fan setting
Light Reduce fan
speed
Fan OFF
Acoustic signal:
When a button is pressed, this is verified by an
acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and + until a signal is
emitted after approx. 3 seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Press the + button or pull out the filter drawer.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.

OPERATION

Switching the fan OFF:
Fan follow-on
Intensive setting:
Maximum power is obtained at the intensive setting.
It is only required for short intervals.
Fan ON and
increase speed
Fan follow-on:
Lighting:
PAGE 6
Press the 0 button.
The displayed goes out shortly
{
afterwards.
Or:
Keep pressing the – button until the fan switches off.
The displayed goes out shortly afterwards.
{
Keep pressing the + button until a
display.
If the intensive setting is not cancelled by hand, the
fan will automatically switch back to step
10 minutes.
Press the button or push in the filter drawer.
!
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the display.
Then the fan switches off automatically.
Briefly press the button to switch the light on and
a
off.
The light can be switched on at any time, even though
the fan is switched off.
Adjusting the brightness:
Hold down the button until the desired brightness
a
is obtained.
appears in the
ç
after
}