Tabla de contenido
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
ASSEMBLY
UNPACKING
This product requires assembly.
„ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
package contents section are included.
„ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
„ Do not discard the packing material until you have
carefully inspected and satisfactorilyoperated the
product.
„ If any parts are damaged or missing, please contact
your authorised Powerworks service cneter for
assistance.
PACKING LIST See Figure 1
„ Power head pole
„ Intermediate pole
„ Handle pole
„ Wrench
„ Scabbard
„ Operator's manual
Before assembly, remove the battery from the tool.
Do not insert the battery until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
CONNECTING THE POLES See figure 2
Before using the pole saw, assembly is required.
„ Set the unit on a flat, level surface.
„ loose the screw cap(1) on the coupler(2).
„ Push in the press button (3) located on the right shaft
(4). Align the release button with the positioning hole
(5) with the direction of the arrow (6) and slide the two
shafts together. Rotate the lower shaft until the button
locks into the positioning hole.
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
English (original instructions)
WARNING
WARNING
OPERATION
APPLICATIONS
You may use this product for the purposes listed below:
„ Limbing
„ Pruning
ADDING BAR AND CHAIN LUBRICANT See
figure 3
Use Lubricant. It is designed for chains and chain oilers,
and is formulated to perform over a wide temperature
range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and
chain oil added. Level should also be checked after every
30
minutes of use and refilled as needed.
„ Remove oil cap.
„ Carefully pour the bar and chain oil into the tank.
„ Wipe off excess oil.
„ Check and fill the oil tank when there is no oil in the
oil tank.
„ Repeat as needed.
NOTE: It is normal for oil to seep from the saw when not
in use. To prevent seepage, empty the oil tank after each
use then run for one minute. When storing the unit for a
long period of time (three months or longer) be sure the
chain is lightly lubricated; this will prevent rust on the
chain and bar sprocket.
REMOVING THE BATTERY PACK See figure 4
„ Press the latch button on the battery pack down and
hold.
„ Grasp the pole saw firmly, and pull the battery pack
out of the handle.
NOTE: The battery pack fits into the handle snugly in
order to prevent accidental dislodging. It may require a
strong pull to remove it.
INSTALLING THE BATTERY PACK See figure 4
„ Align the tongue of the battery pack with the cavity.
„ Grasp the pole saw firmly.
„ Push the battery pack into the handle until the latch
locks into place.
„ Do not use force when inserting the battery pack. It
should slide into position and "click".
2
WARNING
Tabla de contenido
