Tabla de contenido
Idiomas disponibles
Idiomas disponibles
management route ip-address/mask gateway
Configuring the Username and Password
To access the system remotely, configure a system username and password.
•
Configure a username and password to access the system remotely.
CONFIGURATION mode
username username password [encryption-type]
Configuring the Enable Password
Access EXEC Privilege mode using the enable command. EXEC Privilege
mode is unrestricted by default.
As a basic security measure, configure a password. There are two types of
enable passwords:
•
enable password — stores the password in the running/startup
configuration using a data encryption standard (DES)-encryption method.
•
enable secret — stores the password in the running/startup configuration
using a stronger, MD5-encryption method.
Dell Networking recommends using the enable secret password.
•
Create a password to access EXEC Privilege mode.
CONFIGURATION mode
enable [password | secret] [level level] [encryption-
type] password
Creating a Port-based VLAN
The default VLAN (VLAN 1) is part of the system startup configuration and
does not require configuration.
To configure a port-based VLAN, create the VLAN and then add physical
interfaces or port channel (LAG) interfaces to the VLAN.
•
Configure a port-based VLAN (if the vlan-id is different from the Default
VLAN ID) and enter INTERFACE VLAN mode.
CONFIGURATION mode
interface vlan vlan-id
26
Tabla de contenido
