Tabla de contenido
Moto Mods Development Kit_GSG_68018270001A.book Page 2 Tues
Insert & Remove Perforated
Board, Personality Cards
and HAT Adapter Board
Note: Detach the Reference Moto Mod™ from
your phone before attempting to insert or remove
a Personality Card, the Perforated Board, or HAT
Adapter Board.
To insert, push in the edge of the board under
•
the tabs at the top of the housing. Then press
down on the bottom and ensure the 80-pin
connector is properly seated.
To remove, grip the sides of the board, using
•
the notches to get underneath it. Pull up to
unseat the 80-pin connector.
Attach & Detach the
Reference Moto Mod™
To attach, align the camera lens on the back of
your phone with the Reference Moto Mod, and
then align the sides and bottom of the phone with
the Moto Mod until they snap together.
To detach the Reference Moto Mod from your
phone, place your finger in the notch at the
bottom of the Moto Mod and pull it away from
your phone.
2
Insert & Remove Perforated Board, Personality
Cards and HAT Adapter Board
Tabla de contenido
